4/25/2024 0 Comments Openvpn gate sso![]() This domain name only applies to tunnelled packets.Ĭlient Routing: This is used to specify full or split-tunnel rules pushed to the An圜onnect client device. More information can be found in IPv6 Support on MX Security & SD-WAN Platforms - VPN document in Configuring IPv6 for An圜onnect section.ĭNS nameservers: This specifies the Domain Name System (DNS) settings assigned to the client.ĭNS Suffix: This specifies the default domain name or DNS suffix passed to the An圜onnect client to append to DNS queries that omit the domain field. ![]() IPv6 Prefix (MX 18.104+): This specifies IPv6 prefix for An圜onnect to support IPv6 to both terminate a client VPN tunnel as well as IPv6 traffic inside the tunnel. RADIUS timeout: This is used to modify the RADIUS time-out for two-factor authentication and authentication server failover.Īn圜onnect VPN subnet: This specifies the address pool used for authenticated clients. Group Policy with RADIUS Filter-Id: This is used to enable dashboard group policy application using the filter passed by the RADIUS server. Only certificates PEM format (*.pem) are supported at this time.Īuthentication Type: This is used to specify authentication with Meraki Cloud, SAML, RADIUS, or Active Directory. This configuration is only required if you need to authenticate client devices with a certificate. Profile update: This specifies the An圜onnect VPN configuration profile that gets pushed to the user on authentication.Ĭertificate Authentication: This is used to configure the trusted Certificate Authority (CA) file that is used to authenticate client devices. To disable the log-in banner simply leave the banner field blank. If configured, a connecting user must acknowledge the message before getting network access on the VPN. Log-in banner: This specifies the message seen on the An圜onnect client when a user successfully authenticates. For an alternative to DDNS enrolled certificates, see Custom hostname certificates section in this article.Īn圜onnect port: This specifies the port the An圜onnect server will accept and negotiate tunnels on. You can change this hostname by following instructions on the Dynamic DNS (DDNS) article. The DDNS hostname is a prerequisite for publicly trusted certificate enrollment. This hostname is a Dynamic DNS (DDNS) host record that resolves to the Public IP address of the MX. Hostname: This is used by Client VPN users to connect to the MX. The following An圜onnect VPN options can be configured: To enable An圜onnect VPN, select Enabled from the An圜onnect Client VPN radio button on the Security & SD-WAN > Configure > Client VPN > An圜onnect Settings tab.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |